Still, I have to constantly adjust the offset setting (and re-slice every time) now that my MK2 is getting old and the tolerances on the Z axis are not as tight as they used to be. In our latest Cetus3D software, we added one of the most wanted features, Vertical Calibration, whose main purpose is to ensure all three axis perpendicular. In my experience, for bulletproof adhesion you should be so close that you can actually hear a couple clicks during the first layer but none after that. Be careful not to go too close, you'll notice because the nozzle will be rubbing and constantly clicking and the plastic is super thin. Use the + and - buttons to adjust the print head to just touching the paper. Put a piece of paper in between the nozzle and the platform. Use the + button to lower the print head to close proximity of platform. python status esp8266 progress reverse-engineering discovery arduino-library wireshark 3d-printer cetus3d. Press button 5 to move print head to the middle of the build platform. Manual leveling can be tedious and time-consuming, which can discourage people from getting started with 3D printing. Doesn't stick? Re-launch the print with offset +0.2 and see if you get closer. Library for getting the status of the Cetus3D printer. Fully Automatic Leveling and Z-Level Calibration. If it is not the case you have to tell the software how close or far to get to the plate through the offset setting. In calibration you made sure the plate was even,level and the nozzle height was consistent on every zone of it, but this process says nothing specific about the distance of the nozzle from the bed, usually the thickness of a sheet of paper is accurate and within tolerance so you don't need further steps. Mac users could go to Mac App Store to download the latest version. Please go to to download the latest version. Install the Software Cetus temporarily use the UP Studio as its printing software. There is no way and no need to level the build platform. Usually for a new printer, a well calibrated one, the "no raft" mode is sticking the first layer straight away. 1 2 The machine is pre-leveled in factory. Using Cetus software, though, it is hard to be consistent on how "smudged" your first layer is: in fact when it's building the raft it does what you described, automatically assigning an heavier flow for the first couple of layers. Have you tried working on the offset settings? In calibration you made sure the plate was even, level and the nozzle height was consistent on every zone of it, but this process says nothing specific about the distance of the nozzle from the bed, usually the thickness of a sheet of paper is accurate and within tolerance so you don't need further steps. In fact, three nozzle sizes are possible: a 0.2mm HD nozzle for an uncharacteristically high resolution for an FDM 3D printer, a normal 0.4mm nozzle and a 0.6mm nozzle for high speed 3D printing.
0 Comments
Leave a Reply. |